MotoGP 22: Valencia Grand Prix Setup guide - Ricardo Tormo guide, brakes, & more

share to other networks share to twitter share to facebook

After 20 rounds of MotoGP action, there is just one more to tackle before season's end. The Valencia Grand Prix has been hosted by the Circuit Ricrdo Tormo ever since its inception back in 1999.

Valencia has book-ended the calendar for some time now and the MotoGP 22 calendar is no exception. This track may be modern, but it's far from easy, just like the official MotoGP 22 video game.

Table of Contents

Milestone have made another great MotoGP game and 22 has been a breath of fresh air for fans of the fastest two-wheeled racing in the world. Here's our setup guide for Valencia in MotoGP 22.

Advertisement

Tyres

MotoGP 21 Qatar Setup Tyres
click to enlarge
+ 8

By the time we reach Valencia, things have started to cool off in Europe, so the track temperatures aren't too high for the race. There are a lot of wide and long corners here that necessitate at least medium tyres on the front and rears.

Advertisement

Suspension

MotoGP 21 Qatar Setup Suspension
click to enlarge
+ 8

The front suspension needs to be middle of the road for a good compromise between stability and steering responsiveness.The pre-load is the one exception to this, as this has to be down at 2.

Everything else has to be at 4 on the front suspension.

Advertisement
MotoGP 21 Qatar Setup Suspension 2
click to enlarge
+ 8

The rear suspension should be a bit more mixed, but overall, low. The rear pre-load should be down at 2, with the shock absorber compression also at this value. The spring hardness should be at its lowest setting down at 1.

The swingarm connector has to be up at 4, and the shock absorber extension all the way up at 7.

Advertisement

Vehicle geometry

MotoGP 21 Qatar Setup Vehicle Geometry
click to enlarge
+ 8

The Vehicle Geometry should be around middle of the road for a good compromise, just like the suspension. The Steering Head Inclination has to be around 1 for peak responsiveness.

The steering plate position and rear swingarm length should both be set to 3 each. The Trail should be all the way up at the maximum value of 7.

Advertisement

Transmission

MotoGP 21 Qatar Setup Transmission 2
click to enlarge
+ 8

Because of the long corners, you'll need high gears for the most part. The exception to this is the first gear, set down at 2 for good acceleration out of the hairpins.

The final ratio, though should be at 6, with the slipper clutch set to 4 to aid stability.

Advertisement
MotoGP 21 Qatar Setup Transmission
click to enlarge
+ 8
Advertisement

Brake System

MotoGP 21 Qatar Setup Brakes
click to enlarge
+ 8

There aren't many long braking zones here in Valencia, but there are many of decent length. These zones are back-to-back, so you'll need to go with the biggest and strongest brakes to prevent overheating.

So, 355 on the front and the 220 mm on the rear are what we've found to be ideal here.

Advertisement

ECU

MotoGP 21 Qatar Setup ECU
click to enlarge
+ 8

The electronic aids in MotoGP are definitely your friends around Valencia. You'll need to make use of them, and that includes 3 on traction control to ensure smooth acceleration out of slow corners.

The same goes for the engine braking, up at 4 to scrub plenty of speed round the long corners. The anti-wheelie aid can be down at 3 though, mainly because of the inclines and declines being relatively gentle.

Power mapping is best at 3 for a flying lap, but you'll need to turn this around during some points in the race. This is to save fuel and the engine. All of these can be adjusted out on track using the HUD in the bottom-right of the screen.