F1 23 Hungary Setup: Online, My Team, and Career Mode settings

F1 23 Hungary setup

F1 23 Hungary setup

The Hungaroring is known for its lack of straights and technical corners. With this F1 23 Hungary Grand Prix setup, you'll be Hungary for victory.

Update: If you're looking for F1 24 setups, you can find the best F1 24 Hungary setup here.

F1 23 Hungary setup

The Hungaroring is often likened to Monaco without the barriers. High downforce is the only way you can go here, as high wing angles are required to generate the grip to be fast around the corners.

F1 23 has seen multiple updates since release, each changing the dynamics of the car. Here's our updated F1 23 Hungary setup.

Aerodynamics

We recommend 46-42 for the aerodynamic setup in Hungary.

F1 23 Hungary setup aerodynamics
expand image

This sounds high, but downforce is key at the Hungaroring. Plenty of slow, tight corners mean you need your wings at maximum.

Transmission

We’ve gone with 50% on-throttle differential and 50% off-throttle differential.

F1 23 Hungary setup transmission
expand image

This lets the differential assist with the steering, which in Hungary is vital.

Suspension geometry

A front and rear camber of -2.80 and -1.00 respectively is the best for Hungary.

F1 23 Hungary setup suspension geometry
expand image

Front and rear toe of 0.04 and 0.19 respectively will give you that extra steering potential without compromising speed on the rare straight sections.

Suspension

We’ve gone for 30-8 on the suspension and 8-1 for the anti-roll bar. This gives good turn in for the slow and medium-speed corners, but plenty of stability in the chassis to get back on the power without losing the rear.

F1 23 Hungary setup suspension
expand image

Ride height is set to 35-36, lifting the car clear of the bigger kerbs. The higher car also brings more downforce from the wings.

Brakes

100% brake pressure is still the F1 23 meta, while 55% brake bias is a good balance between front and rear for Hungary.

F1 23 Hungary setup brakes
expand image

With the number of braking zones in Hungary, locking up is almost inevitable. Caution on the brake pedal is advised, but this setup will limit the chances of flat-spotting the tyres.

Tyres

Have an opinion on this article? We'd love to hear it!

We suggest a front tyre pressure of 22.5 PSI and a rear pressure of 20.1 PSI.

F1 23 Hungary setup tyres
expand image

This will extend the life of the tyres, but will require extra weaving on outlaps to get the temperature into the rubber.

Adjustments

These setups are intended for intermediate players who may still be using assists like traction control and ABS. However, if you are looking for an extra edge then you can try a few of these adjustments:

  • Decrease the wing levels by 1-3 clicks to improve top speed
    • This will make the car less capable on turn-in and less stable in high-speed direction changes
  • If the car doesn't feel like it is doing what you want on turn-in then raise the front wing a click or two
  • If the car is too loose at low speeds try moving the off-throttle differential up a point or two for more stability
  • For a more "pointy" car stiffen the front suspension & anti-roll bar in relation to the rear
    • This will make getting traction trickier
  • Don't be afraid to move brake bias during the lap. More frontward will give better performance in heavy braking zones, and a rearward for lighter braking zones
    • Lockups are easier to achieve in F1 23 than previous games. Front locking is less catastrophic than rear locking, and which way you go from our mark will increase your chances of a lockup in that direction
  • Add a click of tyre pressure for short online races to improve tyre warm-up!
This Article's Topics

Explore new topics and discover content that's right for you!

F1
Have an opinion on this article? We'd love to hear it!